Contents

Why does it show “No signal found!” while using ClonerAlliance Flint 4KP Pro?

When using ClonerAlliance Flint 4KP Pro device, it may be show a picture as:

image0

Don’t worry, it is easy to solve this problem.

  1. Please make sure the source device is powered on and works normally.

  2. Please confirm the source device is correctly connected to “IN” port of ClonerAlliance Flint 4KP Pro with HDMI cable.

  3. If it is still prompt “No signal found!”, please replace the HDMI cabel between source device and ClonerAlliance Flint 4KP Pro. That will help.

« Does ClonerAlliance Flint 4KP Pro support f... Why does it show “Unsupported Content” whil... »